[T02] How to Load Thermal Paper and Print Correctly

[T02] How to Load Thermal Paper and Print Correctly

1. Load the Thermal Paper Roll Properly

  1. Open the printer's top cover and load the thermal paper roll.
  2. Close the top cover properly.
      Here is a demo video about how to install thermal paper roll of T02 correctly.
      
2. Check the Status of the Printer.
  1. Power on the printer and check the status light.
  2. If the printer's status light is solid red, follow these steps to troubleshoot:
    1. Open the Phomemo App and connect the printer.
    2. Choose an image to printer, the app will display one of the following prompts:
      1. Printer is Out Of Paper
      2. The cover is opened
3. If the App Displays "Printer Is Out Of Paper", please following the steps to reflash the sensor.

      
  1. Power on the printer without install the paper roll.
    (Note: The printer's status light should shows a solid red light.)
  2. Press and hold the power button for 10~20 seconds untill the indicator light flashes green twice, then release the power button.
    (Note: The printer will shut down during the process. Continue holding the power button until the indicator flashes green twice before releasing it.)
  3. Restart the printer and load paper to print again.
            Please refer to the demo video below:
            

      4. If the issue persists, please contact our support team (Email: bestservice2012@outlook.com) and provide the following information.
    1. A screenshot or photo of the app's print error message.
    2. A video of your troubleshooting steps. (Step 1~3).
    3. A photo of the printer's status when it can't detect paper.
      (Note: You need install the paper roll and close the top cover properly fisrt, and the photo need contain the light status)
    4. Your order number, purchase platform, and purchase date.

4. If the App Display "The cover is opened"

      
  1. Check if the top cover is properly closed.
  2. If the issue persists, please contact our support team (Email: bestservice2012@outlook.com)  and provide the SN and firmware version of your printer, the issus can be solved by upgrading the firmware.




    • Related Articles

    • [M08F] How to Load Thermal Paper and Print Correctly

      1. Check the Status of the Printer: Open the printer's top cover and load the thermal print paper. Close the top cover properly. Power on the printer and check the status light. If the printe's status light is solid red, follow these steps to ...

    • How to Print 15/25mm Paper Rolls

      1. How to install the paper roll 1. Our M02S/M02pro/P2S can use 15mm and 25mm thermal paper roll to print. 2. Please follow the instructions below to install a small size paper roll. Please install the 15/25mm paper roll on the far left side of the ...

    • [M832] How to install the paper roll correctly.

      1. Please check whether the paper roll is installed correctly. Press the two open cover buttons at the same time to open the cover. Pull the paper out. Close the printer's cover. Here is a demo video: 2. How to correctly install the small bracket. ...

    • [Tattoo Print] How to Enhance Tattoo Print Quality

      1. Maintain a High Battery Level for the Printer. To avoid compromised print quality, keep the printer's battery sufficiently charged. Should the battery level fall below 30%, we recommend charging it for 2 hours prior to printing. The printer's ...

    • [M832] Supported Print Sizes and Print Demonstration

      1. Printer Suppored Sizes: The M832 printer supports the following sizes: US Letter (216mm), A4 (210mm), 4.33" (110mm), 3.14" (80mm), and 2.08" (53mm). You can use the built-in "Adjustable Baffle" in the printer's paper bin to adjust the width of the ...